Replacement of panel board

[Mariell H]

Hello
Beginner here
Need to replace a board, how do I remove the broken board?

 

[fribygg]

Crowbar

 

[Plupp 405730]

Hammer or crowbar..

 

[Mariell H]

But how do I release it at the rule?

 

[Mariell H]

It goes under the rule

 

[Klass0n]

Unlikely that it is nailed under the rule, loosen it a bit at the top, knock out the nails, and then pull it straight up.

 

[Mariell H]

Unlikely that it is nailed under the beam, loosen it a bit at the top, knock out the nails, and then pull it straight up.

Stuck like a rock!
Any easier suggestions?
Can one pour something into the gap between the beam and the panel to make it release more easily?

 

[Mariell H]

Sitting really tight

 

[Henningelvis]

The terrace is built against the cladding. You need to cut the cladding board at the level of the terrace joist and remove the part above first. Then you can knock away the small piece that sits behind the rule. It's probably nailed as well, so you'll need to get behind it with a hacksaw blade to cut the nails.

Alternatively, you take something sharp, like a chisel or axe, and carefully split the board so it can be removed in small pieces.

 

[Mariell H]

The terrace is built against the panel. You need to cut the panel board at the height of the terrace joists and first remove the upper part. Then you need to knock away the small piece that sits behind the beam. It's probably nailed as well, so you need to get behind it with a hacksaw blade to cut the nails.

Alternatively, you take something sharp, like a chisel or axe, and carefully split the board so that it can be removed in small pieces.

Thanks, we got it loose now.
When we put a new board there, should we hammer it down?

 

[Henningelvis]

Thanks, we got it free now.
When we are going to put a new board there, should we hammer it down?

Preferably not. It's easy to damage the wood if you hammer it. It could leave ugly marks and splinters. Can't you just fit a new board of the right dimension? If you still have to knock on the board, use a block in between.
I strongly recommend painting the new board before putting it in place instead of painting it on site.

 

[Mariell H]

Preferably not. It's easy to damage the wood if you hit with a hammer. There can be ugly marks and splinters. Can't you just insert a new board of the right dimension? If you still have to knock on the board, use a block in between.
I strongly recommend painting the new board before installing it instead of painting it in place.

Thank you so much for the help.