I would like to renovate the staircase in the house. I can easily sand and oil (or varnish, stain etc.) the wooden parts, but I'm unsure about the laminate, or whatever it is, that may or may not be glued with something containing asbestos. Of course, it would be best if it could be removed easily (i.e., without having to do remediation, with everything that entails) and replaced with new laminate or felt. Alternatively, is it possible to paint it with a decent result? 70s red isn't really my thing, I feel.
Wooden stairs with red laminate steps, possibly from the 70s, in need of renovation. The owner is considering alternatives to remove or update the laminate. Red laminate staircase with textured surface, possibly from the 1970s, requiring renovation. Red laminate stair with wood grain side, possibly from the 1970s, featuring a textured surface needing renovation or painting as per forum discussion.
 
Have you tried a heat gun? Might smell like monkey, but should probably get the glue to release.
 
  • Like
AJ82
  • Laddar…
Carpet can probably be placed directly on the existing surface.

Personally, I would build over the steps, and in connection with that, you can lay a new surface that also hides the front edge.
However, I am much more bothered by the open steps of the '70s and '80s than the red laminate...
 
  • Like
AJ82
  • Laddar…
Isn't it just regular linoleum flooring?
We glued down flooring in our old house and attached a trim at the front.
 
  • Like
sturnus
  • Laddar…
Looks like you have the same conditions as we had.

Started by removing the carpet and scraped off the adhesive with a paint scraper before sanding and priming the sides.

A wooden staircase with partially sanded steps and blue tape on edges, ready for painting and finishing.

Made templates out of cardboard and cut out carpet pieces with a steady hand.

Carpeted stair with a beer can and utility knife on the step edge. Oak trim is visible.

The oak trims on the front edges of the steps were varnished with floor lacquer and it seems like your staircase is made the same way.

Carpeted wooden stair steps with oak trim, freshly painted risers and carpet installed using templates; final result of renovation project.

This is the finished result.

Curved staircase with grey carpeted steps and wooden edges, set against a white wall with ambient lighting underneath the banister.

I must recommend choosing a really good paint when you paint so you get a nice surface and it doesn't run or drip when you paint under the steps.
 
  • Like
RoTe and 5 others
  • Laddar…
P-plats P-plats said:
Looks like you have the same conditions as we had.

Started by removing the carpet and scraped off the glue with a paint scraper before sanding and priming the sides.

[image]


Made templates out of paper and cut the carpet pieces with a steady hand.

[image]


The oak strips on the front edges of the steps were varnished with floor varnish, and it looks like your staircase is made the same way.

[image]


Here's the finished result.

[image]


Must recommend choosing a really good paint when you paint so you get a nice surface and it doesn't run or drip when painting under the steps.
Nice!
It would be really nice if we could achieve something similar. Unfortunately, the staircase is also really creaky, and that's probably a problem that should be solved first.
 
  • Like
P-plats
  • Laddar…
AJ82 AJ82 said:
Nice!
It would be really nice if we could achieve something similar. Unfortunately, the staircase is really squeaky too, and maybe that's a problem we should try to solve first.
Ours creaked quite a bit too, so when the carpet was gone, I drove a few screws from the top of the steps out into the outer stringer.
Whether that was right or wrong, I don't know, but there's much less squeaking now, though it depends on the season.

We also chose carpet to make the stairs slip-resistant, and a few years later, we're still very satisfied.
 
  • Like
AJ82
  • Laddar…
P-plats P-plats said:
[bild]
.

Is there some special carpet glue in that can? ;-)
 
  • Haha
P-plats
  • Laddar…
Many homeowners have torn their hair in despair over stairs with glued-on carpets; some are taken away to vehicles with blue lights wearing sweaters with very long sleeves after trying to renovate them.

There are renovation steps to buy, which are simply mounted on top of existing steps without having to remove the carpet pieces first; simple and stylish but unfortunately not cheap. The budget version I chose is to lay pieces of regular laminate flooring and finish with trim, similar to @P-plats but with corner trim that goes up over the stair nose.
 
  • Like
AJ82 and 1 other
  • Laddar…
S sturnus said:
Is there some special carpet glue in that can? ;-)
No, but it gave me a steady hand... :rofl:
 
  • Like
sturnus
  • Laddar…
P-plats P-plats said:
Ours creaked a lot too, so when the carpet was removed, I put in some screws from the top of the steps into the outer stringer.
Whether it was right or wrong, I don't know, but there's much less creaking now, although it depends on the season.

We also chose carpet to ensure the stairs were non-slip, and a few years later, we're still very satisfied.
It sounds convenient if it solves the problem. I would also have chosen felt carpet, but we have cats that like to use such surfaces as vomit/scratch places.
 
  • Like
P-plats
  • Laddar…
Click here to reply
Vi vill skicka notiser för ämnen du bevakar och händelser som berör dig.