OSB or plywood behind drywall?

[wrang]

Is it the same question, if you're using råspont, do you install it horizontally?

Sent from my iPhone 4S using Tapatalk

 

[Elkludde]

Absolutely lying Nail with 63 mm one or two nails

 

[wrang]

Gött thought it felt immediately right to set ändspont/råspont when reading about it.



Sent from my iPhone 4S using Tapatalk

 

[NightBuilder]

I've been thinking about installing a 12mm chipboard screwed on with wood panel on top using hidden nails if possible.

 

[Elkludde]

Nice, it felt immediately right to use tongue-and-groove/råspont when reading about it.

Sent from my iPhone 4S using Tapatalk

End tongue is not necessary to splice continuously, but avoid more than one splice between each post in the same board row.

 

[Snailman]

I have seen that Sävsjöträhus has both horizontal and vertical tongue-and-groove panels in their houses (in one and the same).

I assume that, for example, for interior walls, you have vertical studs = horizontal tongue-and-groove panels,

while for exterior walls, you probably have an extra layer of horizontal 45 studs inside the vertical ones = vertical tongue-and-groove panels.

So I plan to do the same in the house I'm working on now...

 

[SBH]

Chipboard is damn hard to nail into

 

[Johan Gunverth]

particle board is damn difficult to nail into

That's why you avoid nailing into particle boards.
The board is screwed up with particle screws, and the same goes for pictures where you use L-screws. As strong as anything.

 

[prototypen]

Raw boards are advantageously placed diagonally.

Protte

 

[raveper]

I've been considering using 12mm particleboard screwed in with wood paneling on top with hidden nails if possible.

Why the particleboard?

 

[Kjell_G]

Råspont is preferably set diagonally.

Protte

Now it's starting to look like something

Kjell G

 

[Elkludde]

Now it's starting to look like something

Kjell G

Has anyone seen raw plywood diagonally on interior walls??

 

[synpunkter]

Personally, I always set raw pine paneling in a herringbone pattern with a border and concealed nailing behind the gypsum board. d^_^b

 

[Daniel78]

Has anyone seen diagonal raw timber boarding on an interior wall??

I have done it on a couple of walls, the whole wall becomes like a large diagonal brace then.

 

[NightBuilder]

Why the chipboard?

Mostly for higher fire safety, etc. Haven't thought much. It's something I considered when reading about different constructions on the wood guide. I wanted double "boards" since I'm not a fan of the walls with just a single layer I've seen in the buildings I've been in. (just paneling or other board)

Maybe not everyone likes wood paneling everywhere, and it would be good if someone wants to take down the paneling to have something else.
Then it can be useful during construction for stiffness, etc. The paneling can be added later to reduce scars and damages initially.

I can imagine having paneling only halfway up and a smooth painted surface above, etc., or something similar with variation.

Just some thoughts on solutions. It will be quite a while before anything is realized, though.