Have just opened up an old plaster wall to expose the brick wall.
Currently, there is a mix of plaster and coating, and I wonder how I can make it a bit more like it is on the right, but whiter.
Then I wonder which method is best to attach the horizontal beam at the top (which supports the ceiling) to the brick wall so I can remove the vertical studs.
Very interesting question. Unfortunately, I don't have any good answers. But I'm happy to bump the thread for you
Is there anyone else who can help here? Who has experience with a plastered brick wall.
I can add a few more pictures, and a question regarding the gap of 1-2 cm that is far to the left (see pictures). Can you use expanding foam to fill that, and how is it best applied? Is there a difference between expanding foam and expanding foam? How elastic does expanding foam become once it has hardened? I don't want it to crack and leak heat when the walls move.
It turned out to be a bit more work than I initially expected, but on the other hand, I am SUPER SATISFIED!
I thought I'd go through step by step how I did it:
Removed old plasterboard and insulation
Attached the upper beam to the brick wall with 6 M16X400 mm threaded rods (cc60). Used Essex anchoring mass. Also installed a 100x100x400 mm load-bearing beam in the existing hole (visible in the middle)
Removed standing studs
Cleaned the wall from old plaster
Sealed the gap against the outer wall with regular mineral wool
Bricked up the old holes into various shapes (one became a wine rack)
Repaired poor brick joints
Applied a layer of weber fine plaster (weber.cal 145 feather finish) which was then "screeched."
Sanded and filled the cracks in the lower and upper beams.
Primed the wall with Nordsjö silicate fixative (special for indoors)
Painted two coats with Nordsjö indoor silicate (unbroken).
Drilled holes for the electricity for the spotlights
Ran all the electrical wiring
Primed all the wood with Nordsjö adhesion primer (oil-based)
Painted the wood with two coats of Jotun Lady (unbroken white) (oil-based)
Furnished =)
Halfway...
/Anton
Last edited:
Click here to reply
Vi vill skicka notiser för ämnen du bevakar och händelser som berör dig.