Hello, I received a tip about fastening perforated tape in a cross-diagonal pattern on the studs of the exterior wall instead of using regular diagonal braces (it's an old outbuilding that leans slightly, and I want to secure it before insulating) which seems sensible compared to diagonal studs as it doesn't complicate loose-fill insulation, doesn't build, etc.
But how the heck do you tension a perforated tape? I fastened one diagonally three meters on the outside of two standing studs and tried to keep it tense by hand while doing it. Still, I can move it 10-15 cm in both directions after it's screwed in place. I had realized this beforehand, but wanted to give it a try anyway.
Does anyone know how it's usually done?
/A
But how the heck do you tension a perforated tape? I fastened one diagonally three meters on the outside of two standing studs and tried to keep it tense by hand while doing it. Still, I can move it 10-15 cm in both directions after it's screwed in place. I had realized this beforehand, but wanted to give it a try anyway.
Does anyone know how it's usually done?
/A
Last edited:
For larger strap ties for wind bracing, band tensioners are available for purchase. http://www.strongtie.se/media/kap4_bnsp.pdf
/Ingenjören
/Ingenjören
Interesting tips! Then I am a bit concerned about how good it is to use a dead material like steel straps for wall studs made of wood that will want to move a bit if you get it really tight.. But the studs are not supposed to move relative to each other anyway, otherwise it would be impossible to put up drywall etc...