freestanding wall. How do I make the corners?

[Marcus donander]

Hey gang!
I'm building a freestanding wall without a door.
It starts against an existing wall and ends in the middle of the room. How do I best and easily create the end corner nicely?

 

[JA”Snabbe”]

What are you building the wall with?

 

[Marcus donander]

Framed with wood studs and then added OSB and gypsum.

 

[JA”Snabbe”]

You can finish the wall with a door casing in MDF, available in different widths. You can either install one that is a few centimeters wider than the wall, or you can split it and install molding or corner strips.

Like these https://www.hornbach.se/shop/sok/artikel/dörromfattning

 

[Henkan Sundberg]

Have framed with wooden studs and then put on OSB and gypsum

I would have put gypsum on the short side of the wall (that is, the part that ends in the middle of the room). And put on two of these on the corners and filled everything.

https://www.hornbach.se/shop/AquaBe...MIkaS0k9e-6gIVDywYCh2ypQToEAQYASABEgLY1vD_BwE

 

[JA”Snabbe”]

I would have put plaster on the short side of the wall (that is, the part that ends in the middle of the room). And put on two of these at the corners and filled everything in.

[link]

It's a considerably more time-consuming but pleasant alternative.