Hello, first I want to praise the forum, what a great forum, I've received really good help with all sorts of things. Now I have a new question I need help with. I am going to reclad a wall and add insulation, the house is quite tall so there will be a joint or division on the wall. However, the top window in the simple sketch is located under the eaves. I would have liked the division at the solid line, but then the division would be 30 cm at the window level, which probably isn't quite right. If I make the division below, then there will only be short board pieces, but I guess that's what I have to do. Grateful for any advice. Regards, U
Can't you even out that level difference with some trim behind the window casing? It's probably less noticeable than a spliced panel on the long side.