Hello, I'm a new member here but I've been reading the forum for a couple of years and now it's time for some help. I need to replace the old swing gate with an overhead sectional door.
Garage width 8m and ceiling height 2570
Old door 2450x2430
New door 4000x2125
The entire garage is built with leca and the door will end about 0.5m from the door, there is a horizontal beam on the leca that is 45x195, and on top of that are the trusses made of 65x180.
So my question is, what reinforcement is required above the door?
Regards, Petri
Garage width 8m and ceiling height 2570
Old door 2450x2430
New door 4000x2125
The entire garage is built with leca and the door will end about 0.5m from the door, there is a horizontal beam on the leca that is 45x195, and on top of that are the trusses made of 65x180.
So my question is, what reinforcement is required above the door?
Regards, Petri
Thought it would be just as well to build properly at once, worked hard on the garage for 6 months, it was an old private carpentry so they had laid wood flooring on the slab that I tore out, painted the exterior just the front left for next year, sold off 7-8 carpentry machines in the garage, +lots of timber etc. painted the ceiling walls floor inside and finally the biggest things are fixed, going to install a heat pump now and then there will be a little rest from the garage until spring.