Baseboard.

[björnuf]

Hi, I have a question about floor molding at different levels on the same floor, the floor in front of the wood stove is 25 mm higher than the room floor, suggestions on what I should do, block in between,....

 

[BirgitS]

A picture says more than 1000 words

 

[björnuf]

A picture says more than 1000 words

 

[BirgitS]

How high should the baseboard be?
If it is much higher than 25 mm, it can look very nice to cut off 25 mm at the bottom edge of the part of the baseboard that is on the tile. Otherwise, you can place the baseboard at the two heights and miter a piece to connect between them, especially if you also have a sloping threshold strip.

 

[björnuf]

How high should the skirting board be?
If it is much higher than 25 mm, it can look very good to cut off 25 mm at the bottom edge of the part of the skirting board that is on the tiles. Otherwise, you can place the skirting board at the two heights and then bevel a piece to connect between them, especially if you also have a sloping threshold.

Beveling a bit of the corner?, are you a carpenter Birgit

 

[BirgitS]

Cut a bit off the corner at an angle? Are you a carpenter, Birgit

No, but you're not the first one with a similar question. If you think it's difficult to cut a piece at an angle, you can just let the baseboards meet at different heights and then tidy up the short side of the upper baseboard.

 

[björnuf]

No, but you're not the first with roughly the same question. If you find it difficult to cut a piece at an angle, you can let the baseboards just meet at different heights and then neaten up the short side of the upper baseboard.

Thanks for the reply, I'll try that ️

 

[amoreex]

We have it like this with snedkapat:
Nothing you immediately think of in everyday life.

 

[björnuf]

We have it like that with mitre cut:
Nothing you directly think about in everyday life.
[image]

Yes, it turned out well, I'll try it, thanks

 

[amoreex]

Yes it turned out well, I'll try it, thanks

but still have to keep color at home..
I almost forgot to paint end grain