6,287 views ·
20 replies
6k views
20 replies
Attaching rebar in holes
A bit late for tips now, but if you have weak studs and heavy loads, one option is to lay a load of gravel on the ground, smooth it out, and place pressure-treated studs on the gravel.
The two concrete posts are one meter into the ground and 30cm above the surface. It likely requires some effort to get them out of there.
Test-drilled a post with a 12mm bit yesterday and got 20cm down with a hammer drill. Then it went slowly. Thoughts of Jula's rotary hammer from Meec, costing 600 kronor, came up. I read that it drills through concrete like butter. But who knows?
Test-drilled a post with a 12mm bit yesterday and got 20cm down with a hammer drill. Then it went slowly. Thoughts of Jula's rotary hammer from Meec, costing 600 kronor, came up. I read that it drills through concrete like butter. But who knows?
useless said:
It's not enough to drill a few holes and stick some iron in. For the reinforcement to be effective, it must go through the entire post. I don't know how tall they are, but I guess it's more than a few decimeters? If you're going to drill half a meter to a meter, it's probably easier to make a new post.
H
Hallerudsbo
Tool enthusiast
· Värmland
· 3 837 posts
Hallerudsbo
Tool enthusiast
- Värmland
- 3,837 posts
get a lot of new concrete for 600Roger G Olsson said:
The two footings are a meter down in the ground and 30cm above ground. It probably takes some effort to get them out of there.
Test drilled one footing with a 12mm drill yesterday and got 20cm down with a hammer drill. Then it got slow. Thoughts of Jula's drill hammer from Meec, 600 bucks came up. Read that it drills through concrete like butter. But who knows?
I wouldn't bother with drilling.
Fresher concrete is tougher to drill into as well.
I already have the drill. But what you said about lifting the foundation block straight up, I might actually manage it. The paper tube should make for low resistance through the ground. It sounds worth trying!
H Hallerudsbo said:
H
Hallerudsbo
Tool enthusiast
· Värmland
· 3 837 posts
Hallerudsbo
Tool enthusiast
- Värmland
- 3,837 posts
Yes, it can be done.
Otherwise, if you have a swing set for the kids or something similar, there is rope and pulley or hang onto the rope to help lift it up.
Personally, I would have replaced the beam and redone it.
But otherwise, let it be without.
Otherwise, if you have a swing set for the kids or something similar, there is rope and pulley or hang onto the rope to help lift it up.
Personally, I would have replaced the beam and redone it.
But otherwise, let it be without.
Click here to reply