What do you think about this as an alternative to a French wood screw? Called "Träskruv Right XL 6-kant FZV". Planning to fasten 90 cm high 70x70 posts in ground anchors/post spikes that support an 80 cm high fence with sparsely placed planks. Do you think 8x60, one from each side, would be sufficient?
I'm going to build a fence that's about 2m high and I will set the footing blocks "incorrectly," meaning in a way that the screws take all the lateral force if it gets windy, see attached image.
I'm thinking of buying Essve waf, Bauhaus has 8*50, that should do well, right? Using four of those through each beam.
The fence will be about 12m long, with one side attached to a wall and the other end at 90° against a lower fence.
Or, as I just thought of, should I set the footing block the "correct" way so it absorbs the force, then notch the plank so I can still screw one at the bottom?
I'm going to build a fence that's ~2m high and I'll be setting the concrete posts "incorrectly," meaning in a way where the screws take all the lateral force if there's wind, see the attached image.
I'm thinking of buying Essve waf, Bauhaus has 8*50, that should work well, right? Using four of those through each beam.
The fence will be ~12m long, attached on one side to a wall and at the other end at a 90° angle to a lower fence.
Or, as I just thought of, should I set the post the "correct" way so it takes the force, then notch the plank so I can still screw one at the bottom?
[image]
How did you handle the screws and the direction of the posts, and did it become stable?
Click here to reply
Vi vill skicka notiser för ämnen du bevakar och händelser som berör dig.
Mazen said:
