I'm looking for posts/beams for the fence I'm going to build this week. I was planning to use 45x45. Almost everything I find is NTR-AB (not NTR-A) though. I'm planning to set the beam in ground anchors and then mount the ready-made fence sections.
Will NTR-AB work for this or do I need to track down NTR-A? I would gratefully appreciate any link or pointer in the right direction!
Will NTR-AB work for this or do I need to track down NTR-A? I would gratefully appreciate any link or pointer in the right direction!
I was thinking of using such a jordankare: https://www.k-rauta.se/produkt/jord...zW4WhBqbg2LsCTBf0B883xTdDfcdnnbMaAv0LEALw_wcB
Then I assume that the part where the post is attached is above ground. Correct?
Very basic question, it may seem, but better too many questions than too few, I think!
Then I assume that the part where the post is attached is above ground. Correct?
Very basic question, it may seem, but better too many questions than too few, I think!
If the cost is not too burdensome, I would choose mist 70x70 posts.
45x45 looks like a budget matchstick construction in my opinion.
With 45x45, there's a greater risk of them twisting and bending.
45x45 looks like a budget matchstick construction in my opinion.
With 45x45, there's a greater risk of them twisting and bending.
Might as well jump up to 70 x 70, I think. No big deal.
The fence will be around a patio at my townhouse apartment. Approximately 2 x 3 x 8 meters in length. The fence will be about 80 cm high, depending a bit on how low on the post (i.e., the rule) I attach it.
The fence will be around a patio at my townhouse apartment. Approximately 2 x 3 x 8 meters in length. The fence will be about 80 cm high, depending a bit on how low on the post (i.e., the rule) I attach it.