Load-bearing floor structure for a bathtub

[Långbro Fridhem]

Support I can easily get by cutting a small piece of the vapor barrier and then inserting the beam into the insulation.

I don't think that will be necessary. I rested the beam on the beam marked by the red arrow. In turn, it rests with a centimeter on the outer wall beam.

 

[Långbro Fridhem]

Support I can easily achieve by cutting a small piece of the vapor barrier and then inserting the stud into the insulation.

A little curious... how did it go with the bathroom?

 

[d0nnie]

A little curious... how did it go with the bathroom?

Yes, it's done What do you think?

 

[Långbro Fridhem]

Fancy! It must be nice when it's finished.
How did you end up reinforcing the floor structure?

 

[d0nnie]

Looks nice! Must be nice when it's finished.
How did you end up reinforcing the floor structure?

It was solved as we wrote in the thread. Screwed and glued 45x70 on existing beams, both on top and bottom, so it became like I-beams in its section. Turned out well and the floor does not sag in the slightest.

 

[erk_s]

Very nice bathroom. What type of våtrumsmatta is it?

 

[d0nnie]

Very nice bathroom. What type of wet room flooring is it?

It's not a vinyl flooring but microcement on the floor.