Little/no space for door trim and corner board

[frihopper]

Hello!

I'm not really sure what to do. I've built a small shed with a rather narrow width, 1.6 m. I wanted to place the door far out so that I get a small space inside the shed next to the door instead of placing the door more in the middle of the wall where there wouldn't be much space next to the door at all.

The problem, however, is that there isn't enough room for both corner and door trim unless they are made very small. There's 14 cm to the door opening from the side. The door opening is on the left in the picture and is 80 cm (I haven't attached the lintel in the door opening yet but the idea is that the door height should be 190, so the door is 8x19).

Suggestions for a solution are WARMELY welcomed!

 

[NyaTorpane]

Hmmm what kind of panel and potential air gap will you use?

 

[NyaTorpane]

In my head, you should fit 3-inch foder and 4-inch knut.

 

[frihopper]

H

I mitt huvud borde du få plats med 3 tums foder och 4tums knut.

Hi, thanks for the answer!

Doesn't it look strange to have two trims next to each other and also of different sizes?

Will have fjällpanel, no air gap (no insulation).

 

[jonne72]

I don't think you'll think about it once it's in place.
I have foder next to knutbräda in the sunroom and I don't think it bothers.

 

[NyaTorpane]

Don't forget to include a wind barrier at least so you can insulate in the future.
You'll have the lining in the same size and corners in the same size nemas problemas