How to prevent the studs from showing through OSB and drywall?

[Mjärn]

I have built in an Ikea wardrobe. Framed around it and installed OSB and drywall. Then restoration wallpaper. As the title says: How do you avoid the studs showing through the OSB and drywall? You can see where the studs are. They kind of shine through the wall.

It may not be as clear in the picture, but that's the case anyway. On the left side of the picture, it is clearly visible. It would be interesting to know what I did wrong.

 

[Plupp 405730]

You have probably applied too thin a layer of filler in the plaster recesses, and on the cut plaster edges, applied too much filler so that it has become a bump/ridge..

 

[Argastesnickaren]

If it has been carefully plastered before, it should be completely impossible to see where the studs are located.

 

[Mjärn]

You have probably applied too thin a layer of filler in the gypsum recesses, and on cut gypsum edges applied too much filler so that it has created a bulge/ridge..

I was very sparing with the filler. Applied filler where it was needed (between gypsum boards etc..). But how would this make the studs visible?

 

[Mjärn]

If it is thoroughly plastered beforehand, it should be totally impossible to see where the studs are located.

I was thorough... hmm..

 

[Plupp 405730]

A difference of just a few millimeters is noticeable in angled light..

 

[Mjärn]

Just a few millimeters of difference is enough to show in grazing light...

But I used studs. Then directly applied OSB and plasterboard. How can the studs show through?

 

[JohnyS]

Could it be the joint compound edge on the drywall? I cut it off in corners and against openings.

 

[Mjärn]

Could it be the joint edge on the plasterboard? I cut it off in corners and against openings.

Joint edge?

 

[Mjärn]

This is how it looked

 

[JohnyS]

The edge of the gypsum board is thinner to accommodate tape and joint compound.

 

[sinuslinus]

On the right, you can clearly see the recessed joint edge on the drywall. It is usually easiest to cut off 5 cm of the edge in corners and ends so that you avoid having to spackle the entire recess.

 

[Mjärn]

To the right, you can clearly see the recessed joint edge on the drywall. It is usually easiest to cut away 5 cm of the edge in corners and ends so that you avoid having to fill the entire recess.

What? I think the whole board looks the same.

 

[Plupp 405730]

What? I think the entire disc looks the same

Which gypsum have you installed?

 

[fribygg]

I was very sparing with the filler. I applied filler where it was needed (between plasterboards, etc..). But how is this supposed to make the studs visible?

Studs are not visible through OSB and plaster, it's the insufficient filling that's the issue.

What? I think the entire board looks the same

Then you should take a closer look next time or outsource the work.