Gluing threaded rod into concrete?

[matknu]

Hello,
I'm planning to put up a small inner wall and want to attach a steel track to the ceiling. I've drilled holes but there's a lot of reinforcement, and I can only get in 3cm. I thought about gluing in threaded rods in the holes and then securing the ceiling track with nuts, and I'm wondering which glue I should use. Montage adhesive?
Mats

 

[Matti_75]

Use spix. They are only 5x22mm

 

[matknu]

Use spix. They are only 5x22mm[image]

What a thing! Thanks for the tip. I will have to drill new smaller holes... I've drilled 8mm.

 

[jonaserik]

Hello,
I am going to set up a small interior wall and want to attach a steel track to the ceiling. I have drilled holes, but there is a lot of reinforcement, and I can only go in 3cm. I was thinking of gluing threaded rod in the holes and then attaching the ceiling track with nuts and wondering which glue I should use. Assembly glue?
Mats

Now it might be a special measurement where the track should sit, but otherwise, move the hole diagonally about 3 cm so you usually bypass the iron. The iron runs lengthwise and crosswise in the ceiling and is probably bottom reinforcement, hence about 3-5 cm up in the concrete. So it should be a diagonal move.

 

[z_bumbi]

Drill through the reinforcement and use anchor compound? Sacrifice a good metal drill bit with a smaller diameter if you can't get through with the concrete drill bit.