Edge strip - help!

[Nygge72]

Hello, I am in the process of enclosing an existing patio. To install sliding doors, I had to build them "outside" the patio floor, which creates a small level difference. Therefore, I need a 90-degree strip in aluminum or another metal material suitable for outdoor use, ideally 50x50, to place at the "level difference" to achieve a nicer finish on the floor. I have searched online but can't find a suitable site. The length of the opening is 225 cm.

If anyone knows where I can find/buy such a strip, I would greatly appreciate suggestions.

Thanks in advance

 

[Violina]

Hi, I am in the process of glazing an existing terrace. To install sliding doors, I had to build them "outside" the terrace floor, which creates a small level difference. Therefore, I need a 90-degree angle strip in aluminum or other metal material suitable for outdoor use, preferably 50x50, to place at the "level difference" for a neater finish on the floor. I've searched online but can't find a sensible site. The length of the opening is 225cm

if anyone knows where I can find/buy such a strip, I would gratefully accept suggestions

Thanks in advance

Any metal supplier? Like begroup?

 

[sinuslinus]

Glaziers usually have different aluminum profiles.

A sheet metal worker can otherwise bend a sheet.

 

[Aberoni]

Go to the nearest plåtslageri and you will get it fixed pretty quickly.

 

[Violina]

Only certain aluminum can be bent at the right angle if you want a smaller radius, otherwise it cracks.

Bent sheet metal never gets the right appearance (the edges aren't as sharp as on profiles.

Angle iron or L-bar (whatever you choose to call it) probably looks the nicest.

 

[Plupp 282191]

https://www.bauhaus.se/vinkelprofil-aluminium-50x50x3mm-2m