Ceiling panel

[carlbanan]

Have a small query. I'm working on an extension of 4x10 meters with a sloped roof. I've attached lath to the rafters (to secure the plastic and insulation). If you want paneling that runs along the extension, is there any way to install it without placing boards under the lath? If I had planned ahead, I might have fixed the paneling as I insulated, but that’s not possible now.

Grateful for suggestions

//Calle

 

[Bror]

The easiest way is probably to mount another layer of glespanel across the one you have already installed.

 

[carlbanan]

Yes, I've thought about that too, but then another 2 cm of ceiling height will be lost, which is not so good. So I only want to do it if there is no other way.

 

[thomasd79]

you can place the glesen diagonally but it's probably a little late for that now

 

[carlbanan]

It might be possible to take them down and then put them up diagonally again. I'll have to think about it... It's nicer with real paneling than the "panelbrädan" I'm considering. Then again, it's a bit more expensive too... I'll have to check that out.

 

[Bror]

Cut pieces of the glespanel boards to fit against the roof trusses between the glespanel.

 

[thomasd79]

won't it be too sparse then?
I have heard that you should preferably attach the panel at cc 600
but I might be wrong, it probably depends on the thickness of the panel