Need to acquire quite a few meters of a type of profile I've never seen.
It's intended to hold glass for solar panels.
It should probably be made of aluminum.
Can anyone point me in the right direction?
It's intended to hold glass for solar panels.
It should probably be made of aluminum.
Can anyone point me in the right direction?
Member
· Västernorrland
· 12 029 posts
No idea but it should be noted that it could just as well be a customer-specific rail. Not something standard that you flick through in a catalog. So if the company/source is gone, the availability of rails might be gone as well....
That can definitely be the case.
But we hope that's not the case!
If they are no longer affordably available, then we'll have to come up with a special solution.
But we hope that's not the case!
If they are no longer affordably available, then we'll have to come up with a special solution.
Thank you so much for the tip 🙂 I have asked the question to SAPA.
Unfortunately, I don't have access to the dimensions, as no profile remains.
The little I have to go on is that it is at least a 45x45mm stud that the profile is screwed into. Visible on the drawing I posted in the thread.
The forum often excels! But this will probably be difficult..
Grateful for suggestions on alternative solutions.
Unfortunately, I don't have access to the dimensions, as no profile remains.
The little I have to go on is that it is at least a 45x45mm stud that the profile is screwed into. Visible on the drawing I posted in the thread.
The forum often excels! But this will probably be difficult..
Grateful for suggestions on alternative solutions.