Taping outdoor gypsum boards ?

[warg]

Hello hello.

Should you tape the gaps in the joints between the plasterboards on the outer wall?
What kind of tape do you use?
//Warg

 

[Styx]

Otherwise, there are H-profiles that can be placed in the joints - if one insists on using outdoor plasterboard instead of Windy...

 

[Faidros]

Those H-lists seem to be a bit tricky to put in place.

 

[Bror]

The H-piece is useful if you need to join the boards vertically and don't have a stud behind the joint. If the joints are between a stud and battens, no tape is needed, if the battens cross over the joints, it is suitable to use tape to seal the joints. Silver-gray woven tape with good adhesion. Styx, exterior gypsum provides a wind-resistant wall, unlike Windy.

 

[ByggaNytt]

Yes, I can also attest that the moldings are tricky to install, but they are darn good once they are in place

http://www.familjenlindstrom.se/images/byggahus/stomme/utegips.jpg

 

[Styx]

Styx, utegips ger en vindstyv vägg, det ger inte typ Windy.

I guess you mean torsionally rigid wall, and then the internal OSB + plaster gives the same effect..

If you mean wind stiff, we usually put some form of facade outside the Windy, so the wall also becomes wind stiff.

 

[Bror]

I assume you mean torsionally rigid wall, in which case internal OSB + plasterboard gives the same effect..

If you mean wind resistant, we usually put some kind of facade outside the Windyn, so the wall also becomes wind resistant.

No, I mean wind resistant. It often takes a while before you can install interior cladding, and in the meantime, you need to ensure the wall's stability against the elements. A paneling, for example, does not provide that stability, so with something like Windy, you need to add strapping or similar wind bracing to ensure you don't end up with a leaning house. With Gu, you get that built-in.

 

[Mr_XXX]

If you have a rule behind the seams, nothing more is needed. If you are joining short side to short side and get a good fit, I don't think anything else is needed either. After all, it's just for stiffening and as wind protection, so it doesn't need to be airtight.

 

[Daydreamer]

If it takes a while until you put up the facade, it's worth taping the gaps and screw holes with duct tape.
Definitely on the seams you've cut (i.e. those that are open).

 

[monsterbyggare]

Is it not possible to use "innegipsskiva" instead of utegipsskiva on the outside of the house/garage with a wooden facade? What would be the essential difference in the gypsum and what could happen if you still quickly mount the wood panels on the facade?