I am in the process of attaching a narrow drywall to the outer end of a wall that projects straight into the room. The problem is that the metal stud into which the screws should be fastened is located a few centimeters in on the wall. Relocating the stud is not an option, it's simply not feasible in this case, trust my word on that :)

But what should be done, should I try to put an extra layer of drywall on the stud, or try to find a wooden stud and plane it down to the correct dimensions, or how should one proceed?

A wall with exposed metal stud showing partial installation of drywall at the edge, with nearby structural elements in a renovation context.
 
If two narrow strips of plaster and filler are enough, then it works. But I would probably go for splitting a stud for a suitable fit. Possibly just a block every 30cm and a plasterboard on that.
 
A side question here: How do I fasten a drywall to a steel stud without the screw just pushing into the stud? Should I pre-drill the stud or is it just the wrong type of screw if that happens?
 
corre said:
A drywall screw with the right tip screws itself in without a problem.
But you have to press quite a bit. Or maybe I have never had the proper "right" tip... :o
 
Should a rule be supported by something at the bottom, otherwise it serves no purpose? This wall edge doesn't reach all the way to the floor.
 
The plåtregel takes all the load. You only need spacers to mount a gipsskiva at the correct depth.
 
peterwesterlund said:
A side question here: How do I attach a drywall to a metal stud without the screw just pushing into the stud? Should I pre-drill the stud or is it just the wrong type of screw if that happens?
I can recommend screws of the brand Grabber when you're fastening OSB or drywall to a metal stud. They work excellently and can be found at K-rauta and Bauhaus.
 
Click here to reply
Vi vill skicka notiser för ämnen du bevakar och händelser som berör dig.