Sheet metal between facade panels

[Johan-]

Those of you who have chosen to divide the outer panel into more than one row vertically on the facade, what kind of sheet metal did you use to protect the lower section from rain?

 

[smurfen72]

You can have that sheet bent to any measurements you want by a sheet metal worker, and it's common sheet metal used for, for example, window sills.

 

[Nicke-85]

I used standard flashing available at the hardware store with a depth between 40 and 160mm. The only downside was that they were only 2 or 2.5m long, so there are a few joints, but if you go to a metalworker, maybe you can get longer pieces.

 

[smurfen72]

Normally, you don't usually get longer pieces than 2 meters at the sheet metal worker either.

 

[Johan-]

Did you use this type of sheet metal in combination with additional metal details or similar as moisture protection, or only the sheet metal itself?

 

[smurfen72]

I drove with only plåt, it's enough.