11,534 views ·
17 replies
12k views
17 replies
Screws and plugs for skirting boards
Page 1 of 2
Hello,
I am planning to buy red plugs, but which screws and size should I use for the baseboards?
https://www.bauhaus.se/plastplugg-5-5x35-rod-100.html
I will have 12x56mm baseboards:
https://www.byggmax.se/virke/lister/golvlister/trälister/golvsockel-12x56-vit-p08612057
Thanks in advance
I am planning to buy red plugs, but which screws and size should I use for the baseboards?
https://www.bauhaus.se/plastplugg-5-5x35-rod-100.html
I will have 12x56mm baseboards:
https://www.byggmax.se/virke/lister/golvlister/trälister/golvsockel-12x56-vit-p08612057
Thanks in advance
Know-It-All
· Västra Götaland
· 12 313 posts
Or you can buy a thin wide double-sided tape. Using plugs for floor moldings feels insanely bothersome.
It's a concrete wall, is it possible with nails?
It would be nice of you to link the nails or tape you mean.
But if I nail, I'll probably pull the whole wall again when the moldings need to be removed.
Probably plug and screw.
Thanks in advance
It would be nice of you to link the nails or tape you mean.
But if I nail, I'll probably pull the whole wall again when the moldings need to be removed.
Probably plug and screw.
Thanks in advance
Last edited:
nails I absolutely think you should go for.evoline said:
no problem to dismantle the moldings later just use a crowbar.
They look so much nicer, you can even have the nails lacquered in the correct color so that they blend into the molding.
https://www.bauhaus.se/sockelskruv-6st-fp.html I usually use these, there are a few different variations. I usually measure where I want the screw on the trim, then screw in the screw against the wall so I get an exact mark where I should drill and plug. Good luck!
https://www.beijerbygg.se/store/privat/fästdon/spik/spik-övrigt/sockelspik?artikel=152451
Here is an example, but just google sockelspik and you'll find tons.
Here is an example, but just google sockelspik and you'll find tons.
If it's a lättbetong wall, there is white listspik: https://www.beijerbygg.se/store/privat/fästdon/spik/spik-övrigt/listspik-lackad-vit?artikel=470527
Is it possible to use these wood screws but in a different size with a red plug?
They are much cheaper than the Minikubik ones linked, which cost 84kr for 6 pieces.
I think I'll skip nails, it was nailed before and removed the list and wall with a crowbar.
I wanted to be able to remove the list without damaging the wall.
Thanks for all the tips
They are much cheaper than the Minikubik ones linked, which cost 84kr for 6 pieces.
I think I'll skip nails, it was nailed before and removed the list and wall with a crowbar.
I wanted to be able to remove the list without damaging the wall.
Thanks for all the tips
Does this work with red plugs?
http://www.clasohlson.com/se/Listskruv/Pr409574002
https://www.bauhaus.se/plastplugg-5-5x35-rod-100.html
Thanks in advance
http://www.clasohlson.com/se/Listskruv/Pr409574002
https://www.bauhaus.se/plastplugg-5-5x35-rod-100.html
Thanks in advance
No, for a red plug you need a screw that is 4-5 mm in diameter: https://sv.wikipedia.org/wiki/Plugg#Plastplugg
The molding screw you linked to is 3 mm.
The molding screw you linked to is 3 mm.