Load-bearing wall

[Mangan74]

Hello, I am going to fix our kitchen and would need to tear down a piece of wall, and I wonder if it could be load-bearing?
I am attaching a drawing to see if you can answer this. Wall marked in red.

 

[Mangan74]

This is a fairly flat roof where the trusses run from the wall between the dining room and the living room, then towards the kitchen.

 

[BirgitS]

Welcome to the forum!

Do you also have a sectional drawing?

What do the trusses look like, are they the so-called fackverkstakstolar?
You can upload a picture of them if it's not clear from the sectional drawing.

 

[Mangan74]

No, I can't find anything. I took some pictures but they might not say much.

 

[Mangan74]

Welcome to the forum!

Do you also have a section drawing?

What do the trusses look like, are they so-called truss rafters?
You can upload a picture of them if it's not clear from the section drawing.

Welcome to the forum!

Do you also have a section drawing?

What do the trusses look like, are they so-called truss rafters?
You can upload a picture of them if it's not clear from the section drawing.

 

[Mangan74]

Think it might be pulpetstakstolar.

 

[Mangan74]

These are not my drawings but taken from the internet. I am trying to find my section drawings but do not know how it is going.

 

[BirgitS]

In any case, your pictures from the internet look like truss roofs, and then normally no interior walls are load-bearing on the floor below the loft. But wait a bit, as an answer from someone more expert than I am might come.

Do you have other drawings?
The section drawing usually comes with facade drawings.

 

[Mangan74]

In any case, your pictures from the web look like truss roof structures, and normally no interior walls are load-bearing on the floor below the attic. But wait a bit, and there may be responses from someone who is more of an expert than I am.

Do you have other drawings?
The section drawing is usually together with the facade drawings.

I can't find anything, unfortunately.

 

[justusandersson]

Your photos from the attic show parts of truss rafters. It would be nice to know that it looks like that all the way through. If it does, as BirgitS says, there are no load-bearing partition walls.

 

[Mangan74]

The whole way? Is it like from one end to the other or what do you mean?

 

[justusandersson]

Photograph the entire truss, even if it requires more photos.

 

[Mangan74]

Now I have obtained the drawings. It doesn't seem like any interior walls are load-bearing if I'm interpreting this correctly. X load-bearing exterior walls even if X is a bit outside the square.

 

[Mangan74]

Photograph the entire truss, even if it requires more photos.

Cantilevered truss rafters made of wood was also mentioned, so it seems calm.

 

[justusandersson]

Yes, it's cool!