Help with Vapor Barrier in Knee Wall/Side Attic

[OXYD]

I have a question that I need some expert help with.

I'm in the process of converting an attic space into a closet. I've started the plastic sheeting. Not a fun job. Such fiddly work

There's a piece that I'm not quite sure about. I've started a strip of plastic at the edge towards the wall. It should be attached to the plastic coming from the ceiling and to the plastic lying on the floor. So far so good.
But is it okay to tape a strip of 40-50cm over the beams as I've begun in the picture? The plastic should then be secured to the ceiling.
Or should I cut away and have as little plastic as possible over the beams and tape directly to the floor?

 

[OXYD]

Came up with another solution by overlapping under the beam instead. So the question is no longer relevant 😎 Thanks

I have a question that I need some expert help with.

I am in the process of converting an attic into a closet. I've started the plastic sheeting. Not a fun job. Quite fiddly

I have a piece that I can't figure out. I've started a strip of plastic along the edge towards the wall. It will be attached to the plastic that comes from the ceiling and the plastic that lies on the floor. So far, so good. But is it OK to tape a strip of 40-50cm over the beams as I started in the picture? The plastic will then be attached to the ceiling. Or should I cut away and only have as little plastic as possible over the beams and tape directly to the floor? [image]