Member
· Västra Götaland
· 780 posts
We are going to cut a round hole in a countertop. I want a simple plastic trim around it to cover the edge, which won't be 100% perfect (laminate + sawdust + jigsaw usually means some rough edges).
The problem is that I can't find a suitable 90-degree or U-shaped edge trim that we can use!? It should preferably be flexible as well since the hole, as mentioned, is round...
I have been to two building suppliers in town, but no one knows what we can use.
The countertop is from IKEA, http://www.ikea.com/se/sv/catalog/products/50237533/
28 mm thick.
Can anyone recommend something?
The problem is that I can't find a suitable 90-degree or U-shaped edge trim that we can use!? It should preferably be flexible as well since the hole, as mentioned, is round...
I have been to two building suppliers in town, but no one knows what we can use.
The countertop is from IKEA, http://www.ikea.com/se/sv/catalog/products/50237533/
28 mm thick.
Can anyone recommend something?
Member
· Västra Götaland
· 780 posts
20 cmJoco_ said:
Member
· Västra Götaland
· 780 posts
Good thinking, would have been perfect but it's too small.
However, the holes are not sawed yet, so if there's a similar variant but larger, that would be great.
We need at least 10-15 cm in diameter.
However, the holes are not sawed yet, so if there's a similar variant but larger, that would be great.
We need at least 10-15 cm in diameter.
