Drywall: Forgot to cut bevel in corners - spackle?

[pwskg]

Hello,

I was a bit quick when I put up the gypsum boards and forgot to trim the bevel on one of the boards in an inner corner.

What do you think, should I leave it and live with the small indentation or try to plaster it?

 

[Henkan Sundberg]

Hi,

I was a bit quick when I set up the plasterboards and forgot to trim the bevel off one of the boards in an inside corner.

What do you think, leave it as it is and live with that little indentation or try to plaster it?

Plaster, you're going to put a tape there anyway.

 

[C.Lundin]

Why would you want to cut it off..? If so, I've done it wrong many times, but I actually think it makes things easier.

 

[pwskg]

If you have two chamfers facing each other in a sense, it becomes like a small "ditch" there, so usually a few cm of the boards that are supposed to sit there are cut away.

 

[pwskg]

Spackle, you’re going to put a strip there anyway.

[media]

Usually just use silicone in the corners

 

[Henkan Sundberg]

Usually only use silicone in the corners

Usually only use silicone in the corners

Does it look nice, silicone isn't paintable?

 

[pwskg]

Will it look good, silicone is not paintable?

Typed wrong, meant latex sealant

 

[Henkan Sundberg]

Wrote wrong, meant latex sealant

Got it.

But to answer your original question, I think you should use putty. It will look the best with or without tape.