Hello.

I bought a K8 Chin-up bar from Atletica. It should be mounted with M10x100 screws in the ceiling with ø12-60 plugs. A total of 8 screws.

My gut feeling says that 10 cm screws in a typical indoor ceiling/floor made of concrete might be borderline too long?

I plan to use a hammer drill with a ø12 bit.

I also think the plugs seem a bit short (60 mm), I mean the whole screw must go into the ceiling (100 mm)?

I appreciate your help.
 
  • Close-up image of a black M10x100 screw next to a ruler showing length, used for mounting a chin-up bar in a concrete ceiling.
  • Ceiling view for installing a chin-up bar with consideration for screw length and wall plug size in a concrete ceiling.
Forget the crappy screw and plug. Buy concrete screws from a proper hardware store that can help you with the sizing.
 
  • Like
Signator
  • Laddar…
Detta är ett filigree ceiling i vilket installationer ofta läggs innan betongbeläggningen hälls. Av denna anledning skulle jag vara försiktig med att borra mer än 6 centimeters - detta är tjockleken på det prefabricerade elementet och du kan säkert borra i det. Självklart kan du stöta på förstärkning, men inte rör eller kablar.
Och jag menar att borra från botten.
 
  • Like
Signator
  • Laddar…
S sturnus said:
This is a filigree ceiling in which installations are often laid before the concrete overlay is poured. For this reason, I would be careful drilling more than 6 centimeters - this is the thickness of the prefabricated element and you can safely drill in it. Of course, you may encounter reinforcement, but not pipes or cables.
And I mean drilling from the bottom
Jag hittade en gammal ritning. På denna är 1 cm = 1 meter, och området jag markerat är taket/golvet där jag tänkt borra. När jag mäter ser det ut som om golvet/taket är ca 20-25 cm, men det kanske är mycket mer än bara betong bjälklaget? Det är ett radhus från 1977.
 
  • Blueprint section of a 1977 townhouse showing a marked area of 2.410 meters, indicated in blue, highlighting the ceiling/floor for drilling.
Det du pratar om är tjockleken på hela taket. Filigran is a prefabricated element that is usually 6-8 cm thick and that fulfills the function of formwork. Reinforcements protrude from it to connect with the load-bearing layer, in which installations are often placed. Therefore, if you drill deeply, you can damage them.
 
  • Like
Signator
  • Laddar…
It was about 22.5 cm of reinforced concrete, all the way through.
 
Matti_75 Matti_75 said:
Screw the lousy screw and plug. Buy concrete screws from a real hardware store that can help you with the sizing
Went down to 8 cm. It should hold about 240 kg.
 
Click here to reply
Vi vill skicka notiser för ämnen du bevakar och händelser som berör dig.