Y
Now that I started tearing down the wallpaper, I discovered that all the walls have thin masonite boards, no drywall... I had planned to tear them down to soundproof all the walls... But drywall is much thicker than these, so the rooms will be smaller, and everything just feels messed up...

There is thin renovation drywall, but...

Should I let the masonite stay, is there any advantage to masonite boards at all?

I'm considering letting the ones against the outer walls stay while some partition walls get opened up... but then the question is if I should use new masonite or thin drywall instead... it bothers me that the rooms get smaller even if it's just a few millimeters...
 
  • Like
MLindstrom
  • Laddar…
C
Yes, if you have a room that is, say, 4x4 meters and you switch from 3mm masonite to 13mm plasterboard, the room becomes about 0.016 square meters smaller. Dreadful. :)
 
  • Like
Hampus Chenon and 1 other
  • Laddar…
You can very well use masonite as wall covering indoors. If you haven't noticed anything negative yourself, then my tip is don't touch anything that works!
 
Have you removed a masonite board and checked how thick it is? The masonite used as wall cladding in my holiday home from the 60s is about 11 mm thick, and I would be surprised if yours is thinner.
 
  • Like
mamikawaii
  • Laddar…
Y
in the kitchen, I had a large hole, where I could measure a 10mm thickness on the board, though I suspect I might not be so lucky with the others.

People say that "living" material moves more, and it's either because of that or settling that the wallpapers have cracked in some places...

(built 1981, modular house, 2 meters foundation)

What thicknesses of plasterboard are available?
 
13mm gypsum is standard, no real reason to take anything else...

Renovation gypsum is only 6mm, though it might work well to place it on top of the masonite...

For an interior wall, you can build with only single gypsum on the framework/insulation, but for better stability and greatly simplified ability to mount cabinets and shelves, you sometimes build with an OSB board under the gypsum. (Strongly recommended for example kitchens...), in other cases, you sometimes use double layers of gypsum.

One of the advantages of gypsum over masonite is its fire resistance...
 
Last edited:
Yrrol said:
in the kitchen I had a big hole, where I could measure a 10mm thickness on the board, although I suspect I won't be so lucky with the others.
Yes, I would bet that it's the same boards throughout the whole house. Why do you think it's different?
 
Y
because the kitchen cabinets etc. hung there... others give a flimsy impression when you knock on them, but then again, they are empty on the inside, so that might be what's giving that impression, hence my desire to open and insulate...
 
  • Like
BissyM
  • Laddar…
Well, but surely they haven't attached the kitchen cabinets only to the sheet? The reason I don't think it's thinner than 10 mm in other parts of the house is that the entire wall would otherwise sway between the studs. If it's c/c 600 and you have a masonite board at 3 mm, the whole wall will bend just by supporting yourself with your hand.

Have you put up any paintings on the wall? Did the whole wall sway with each hammer blow when you put up your hook? :)
 
Y
well yes they are stable in that sense... but it doesn't change the terrifying fact of having to install thicker boards even if the rooms decrease minimally, hehe...

Is renovation gypsum much weaker? rather the rooms become larger.. :)
 
You mean the entire 3 mm thicker walls? If you have a couple of layers of wallpaper on the old walls, it evens out. Renovation plasterboard is 6 mm and not made to stand freely without support behind.
 
doesn't change the horrific need to mount thicker boards even if the rooms decrease minimally
Lucky you're not doing like me, adding insulation from the inside, that's 10 cm that the room shrinks on all outer walls.... how about that :)
 
Adding insulation from the inside is not fun.
 
Y
There was 9mm outdoor gypsum... what happens if you use that indoors? Tempted to rather spackle out that millimeter than to have 3 millimeters too much.
 
Put up renovation plasterboard everywhere.

What difference does 6mm make? Except for issues around doors and windows?
 
Vi vill skicka notiser för ämnen du bevakar och händelser som berör dig.