Hello!
I have read a bit about building descriptions for metal roofs and encountered the materials "ströläkt" and "bärläkt". But I haven't seen what the dimensions in millimeters are for these materials.
It would be great if someone could specify their dimensions.
(I assume the names correspond to a specific dimension.)
Best regards,
Fredrik
I have read a bit about building descriptions for metal roofs and encountered the materials "ströläkt" and "bärläkt". But I haven't seen what the dimensions in millimeters are for these materials.
It would be great if someone could specify their dimensions.
(I assume the names correspond to a specific dimension.)
Best regards,
Fredrik
you can run with 22x 34 mm on both..... However, I would put a 34 on its edge on the bottom panel, if you're not going to have any sheet metal there..... This is to raise the last panel...,...
in this one, the dimensions are included:
http://www.armat.se/documents/solstadtaket_montering.pdf
http://www.armat.se/documents/solstadtaket_montering.pdf
Hello!
A thousand thanks for the answers!
Dad and I were pondering a bit about this.
So I said we should ask on byggahus.se.
Dad was really impressed when I got a quick response from you!
Again, a thousand thanks!
Fredrik
A thousand thanks for the answers!
Dad and I were pondering a bit about this.
So I said we should ask on byggahus.se.
Dad was really impressed when I got a quick response from you!
Again, a thousand thanks!
Fredrik