This is how the transition between the stair railings looks. If I'm not completely mistaken, they're supposed to be at an even level, not with a jump of 20-25cm in height.
Is it properly installed or was someone drunk on the job? :(
We've filed a complaint for it to be adjusted so that it looks good, but we haven't received any response from the home builder yet on whether they intend to fix it.
 
  • A staircase handrail transition with a noticeable height difference of 20-25cm, questioning proper installation and awaiting correction.
Last edited:
It looks funny.

Hard to see in the picture, but why is the higher railing covering the trellis?
 
S
what is the measurement up to the bottom edge on them? at the stair steps then.
the right one may have been done so that they didn't cut it because it might have looked strange when you didn't have the railing for the corner.
it probably has the right measurement at the stair step
 
Here is a picture from a bit further away, as well as the other railing corner; they don't seem to have hit the mark there either :(
 
  • Wooden staircase with railing corner misalignment visible.
  • A wooden staircase corner with a misaligned railing on the right wall, showing construction imperfections.
SBH said:
what is the measurement up to the bottom edge of them? at the steps then.
the right one might not have been cut because it might have looked strange when the railing wasn't at the corner.
probably it has the correct measurement at the step
The left one is 115cm from the middle of the step below, and the right one is 103 from the middle of the step below that.
The funny/tragic thing is that it looks different in every house, there are several similar houses built in the same round.
 
Oh no!
Complain!
There is a specific measurement for mounting staircase railings, but common sense can be activated too, right?
 
shogo99 said:
The left one is 115cm from the middle of the step below, and the right one is 103 from the middle of the step below it.
But what if you measure the upper part a little further up the stairs then? If you look at the stringer, you can see that it becomes less steep when the stairs go out into the corner. I don't know how they usually do it in new houses, but in the older houses where I checked how the railing is placed, they have used curved railings so they have the same shape as the stringer.
 
mulpac said:
If you look at the stringer, you can see that it becomes less steep where the stairs go out into the corner. I don't know how it's usually done in new houses, but in the older houses where I have checked how the railing is attached, they have used curved railings so they have the same shape as the stringer.
I was wondering about that too. I don't know if it has to be exactly like in the pictures, but it must look a bit strange somewhere if you have straight handrails on such a staircase. Even height over the steps is definitely not achievable no matter how they mount them.
 
The top edge of the handrail should be 900 mm above the front edge of the step.
Ideally, the lower handrail should be lower than the upper one. You have to tolerate the fact that they do not align in the corners when you have straight handrails.
 
Last edited:
Are you sure about that Immobil? I think it looks completely crazy. Which house manufacturer builds like this?
 
Yes, with straight handrails, you can never get it to align in the corner. When installing the lower handrail, you often have to compromise a bit and not strictly adhere to the 900 millimeters.
 
Immobil said:
The top edge of the handrail should be 900 mm above the front edge of the step.
Technically, the lower handrail should be lower than the upper one. You have to put up with them not aligning in the corners when you have straight handrails.
Is it stated in any regulations that absolutely cannot be deviated from?
Then one might think that you shouldn't have to "put up" with ugly end results. Especially not when it looks like in the thread....
 
You mean that the practice is still to ensure that the mentors align?
 
No, it's not possible with straight handled supports. 900 mm is widely accepted among staircase manufacturers.
 
The strangest thing is that it looks different in all the houses produced in the same etappl, it feels like they have simply installed them without measuring anywhere.
 
Vi vill skicka notiser för ämnen du bevakar och händelser som berör dig.