Earlier, I wrote about how satisfied and content I was while cutting boards for the storage facade. Upon installation, I discovered that the old sill was also damaged in one area. I don't see any problems with replacing it, but I'm looking for tips on how to solve this easily with the old measurements being 3 by 3 inches. Does anyone know if old measurements are sold in places like Malmö or so?
I would prefer not to hand-saw larger beams and my idea of taking a 70x70 and filling it out with a thin plank doesn't seem entirely sensible.
I don't want to cut and splice existing beams. Just replace the old damaged sill...
The easiest way is to buy a 95x95 rule (available at Beijer, among others) and cut it down if you have a saw with a sufficient blade/band saw. Otherwise, you will need to go to a smaller saw or a specialty carpentry shop. 75x75 is not available pre-made at building supply stores. I don't know if the dimension is needed in your case, but generally, it's good to choose timber with a square cross-section for soles. Soles are subjected to large lateral forces, and then it's good to have a large amount of material. In really old houses, the sole is almost always square.
I'll see how I can solve it. Unfortunately, the woodworking shop in the office basement is filled with moving boxes indefinitely, so I can't cut them there. And on my workdays, I don't get home with the commuter bus until 18.15 when my local carpenter workshop is closed. I also have a feeling Hejdes no longer cuts such things for customers.
I'm seriously considering buying a table saw, but it's a cost that's difficult to justify. Maybe the circular saw can do a bit of work, a cut from each side.
Anyone selling a Dewalt dw745 for half the price..?
I tested with the circular saw today. I only had 45x95 but it went smoothly.
And as usual, I forgot to check that two studs really had the same dimensions. I placed a stud next to it as support for the saw but it was a few millimeters narrower, so when I pressed, the saw tilted. I only noticed it a bit later when I changed my grip. It's always something.
And the sill is really bad? It almost looks like there's a wane (bark) at the bottom of the picture. If the wood isn't soft and rotten and/or damp, you don't need to replace it at all...
Addition: I see the thread is from last year. Darn...
