My door is leaning

[Mikael_Swe]

How do you adjust a door that is leaning? Is it just tightening the screws?

 

[Tompafix]

How do you adjust a door that is leaning? Is it just a matter of tightening it?

Depends on what is leaning. If the frame is plumb, tightening the frame screws won't help. However, it looks like the door has sagged, just like doors do after a while.
In that case, you need a hinge adjuster and bend the hinges back. In this case, the upper hinges.

 

[Mikael_Swe]

Depends on what is leaning. If the frame is level, adjusting the frame screws won't help. The door, however, seems to have sagged, just as doors do after a while.
In that case, you need a hinge adjuster and bend the hinges back. In this case, the upper hinges.

Why doesn't it work? These hinges cannot be adjusted

 

[Tompafix]

Why doesn't it work? These hinges can't be screwed on

You have to bend/break the hinge. You need to use a bit of force.

 

[Mikael_Swe]

You have to bend/break the hinge. You have to use a bit of force.

Unfortunately, I don't think these hinges can rotate. The door will fall off if I use force. Are you really sure?

 

[Mats-S]

The door will fall off if I pull

Yep, if you're unlucky, you might pull the hinge out of the fitting. From that experience, I usually take the more complicated but safer route and:

1. Remove the door
2. Loosen the hinge that needs adjusting
3. Place the hinge in a sturdy vice
4. Take a smaller sledgehammer and strike the hinge to the desired shape. Use something as a buffer between the sledgehammer and the hinge when you strike.
5. Install it and test if the alignment is okay.

Yes, it takes a little time, but there's no hassle with hinges that have torn apart the door or frame...

 

[Tompafix]

Check out this video and you will understand how to do it. You shouldn't twist or lift the door. Start by checking that all screws in the hinges are tight and that the frame is level/plumb.