Interior wood paneling with tongue and groove and holes for electrical outlets
I am installing standing paneling (20mm thickness) with a groove. Encountering a problem when I have an outlet that prevents me from fitting the panel board against the previous board. The electrician said the cover only allows for about 5 mm on each side of the cut-out hole, which means it will probably be visible if I remove whatever is preventing me from pushing the board in from the side.
I screw each board into the groove with a baseboard screw.
How would you have done it?
I screw each board into the groove with a baseboard screw.
How would you have done it?
Remove the board that is there. Glue the two boards together and then assemble.