I am going to install an inspection hatch for the attic space.
I have support beams with 1200 mm on center between each other and then I have spaced lying 30 mm on center.
I have bought a pre-made inspection hatch 540 * 790 with a frame that I will install.
My question is how do I frame and mount the hatch in the best way?
I have support beams with 1200 mm on center between each other and then I have spaced lying 30 mm on center.
I have bought a pre-made inspection hatch 540 * 790 with a frame that I will install.
My question is how do I frame and mount the hatch in the best way?
what kind of calendar window is it then?
the ways frame with 2*2
what does it become on the glesen?
what does it become on the glesen?
When you say set a frame, can you explain more specifically? I'm not entirely sure what you mean.
As I understand it, the hatch frame should be in line with the plasterboard, and then you add trim around it. Is that correct? Because the hatch then protrudes slightly from the hatch frame.
When I make the frame 2*2,
where do I attach it, in the studs?
and what dimension of timber should it be?
Grateful for a bit more specific info as you can see ;-)
As I understand it, the hatch frame should be in line with the plasterboard, and then you add trim around it. Is that correct? Because the hatch then protrudes slightly from the hatch frame.
When I make the frame 2*2,
where do I attach it, in the studs?
and what dimension of timber should it be?
Grateful for a bit more specific info as you can see ;-)
Didn't know such things existed, what might it cost?
I assume it's available at Hornbach?
I assume it's available at Hornbach?
you can make it like an "H" except with double horizontal lines (2tum2=45'45).