E empame #1 Member · Uppsala · 233 posts 22 Nov 2012 at 11:50 PM empame Member Uppsala 233 posts 22 Nov 2012 at 11:50 PM #1 How do you make nice corners in the best way? If everything is as it should be, there's no problem, but if the frame sticks out 2-4mm from the wall, it's almost impossible to get it right.
How do you make nice corners in the best way? If everything is as it should be, there's no problem, but if the frame sticks out 2-4mm from the wall, it's almost impossible to get it right.
C cecar33 #2 Member · Norra Halland · 3 359 posts 22 Nov 2012 at 11:59 PM cecar33 Member Norra Halland 3,359 posts 22 Nov 2012 at 11:59 PM #2 Shim behind to create neat corners and seal with latex
J JOW #3 Member · Uppsala · 2 816 posts 23 Nov 2012 at 12:16 AM JOW Member Uppsala 2,816 posts 23 Nov 2012 at 12:16 AM #3 One can miter two angles simultaneously, if one has such a saw... One at 45 degrees, and the other to compensate for the board's inward tilt. So that the saw blade tilts a few degrees, and is angled at 45 degrees.
One can miter two angles simultaneously, if one has such a saw... One at 45 degrees, and the other to compensate for the board's inward tilt. So that the saw blade tilts a few degrees, and is angled at 45 degrees.
mycke_nu #4 Member · Gotland, Sudret · 12 280 posts 23 Nov 2012 at 7:15 AM mycke_nu Member Gotland, Sudret 12,280 posts 23 Nov 2012 at 7:15 AM #4 Saw a thin strip with the right width and place it behind the trim. Apply a flexible sealant where the gap is too small to fill with wood.
Saw a thin strip with the right width and place it behind the trim. Apply a flexible sealant where the gap is too small to fill with wood.
