Cut porch posts straight and to the same height

[lalander]

I have 30 posts on the terrace 70x70 that
need to be trimmed so they are exactly the same height and the cut is straight since I will be placing a top rail on them.
I would gladly receive smart tips on the best way to do this.

 

[mexitegel]

Laser to get the level, then you put a plank on each side and clamp it with clamps. You saw with a sharp handsaw.

 

[topmount]

Cut a drainage pipe to the right height, slide it over the pole, and bring out the hacksaw.

 

[Patzie]

As above, with a laser for leveling and a good circular saw, it becomes straight and nice. If it doesn't go all the way through, take the fogsvans in the cut and saw the last part.

 

[Mellanbarn]

Same height from what?
From the terrace is easiest, cut a board to the right length and support the circular saw.

 

[Plupp 405730]

If you don't have a laser, bricklayers' string or chalk line works excellently, I usually cut with a circular saw but it can be done by hand as well.

 

[lalander]

Use a laser to get the level, then place a board on each side that you clamp with clamps. Cut with a sharp handsaw.

Thanks, I don't have a laser though, but it could be a reason to buy one.

 

[mexitegel]

Exactly! Absolutely right! 👍😀