Finns inte 6.5mm hylsor?

[blork]

Need to put a ventilation screw in a tight spot. Can't fit a screwdriver but with the right hex socket and small handle it should work. Of course, I have all sizes except the one I need. Unfortunately, 6mm is too small and 7mm is too large, and 6.5mm can't be purchased? What size is it really?

 

[Henrik 75]

https://www.amazon.se/PROXXON-23715-Hylsnyckel-5mm-Storlek/dp/B002Z8F6K4

Then there are many more places even if it is not so common.

 

[cpalm]

Thumb size (1/4") in other words...

 

[Jarlingar]

It's 1/4" and a standard bit holder (without bits) fits Rolex 👍

 

[blork]

It's 1/4" and a regular bit holder (without bits) fits Rolex 👍

Oh, seems like it fits indeed! Unfortunately, I don't have a bit holder for my small ratchet handle. 😀

 

[Jarlingar]

Well, if it's ONE screw just use a small adjustable wrench then 😉
Otherwise, there are bit holders for 1/4" ratchet available in many places.

 

[blork]

Well, if it's ONE screw then just use a small adjustable wrench 😉
Otherwise, bit holders for 1/4" ratchet can be found in many places

Yes, but it's hard to apply force with an adjustable wrench here and get through two metal sheets.

Could this work? https://www.amazon.se/BRILLIANT-TOO...sprefix=bitshållare+spärrskaf,aps,157&sr=8-25

 

[Jarlingar]

Yes.
But it can be bought in various places, you don’t have to order it.
Or do you not have a PH2 that fits the ratchet?

 

[blork]

Yes.
But it's available for purchase here and there, you don't have to order it.
Or do you not have a PH2 that fits on the ratchet?

I probably had one but it's gone. If I had it, I could have used regular bits too, of course. I have prime anyway, so it'll be delivered home by tomorrow