Control and Removal of a Potential Load-Bearing Wall. Tips needed!

[Cookiiee]

Hello, Looking for a structural engineer in southern Skåne for checking load-bearing capacity and drawing for reinforcement if necessary.

Do you have any tips on good structural engineers in the area?

Tips are heartily welcome as it is not very easy to find someone who takes on small jobs.

 

[Tompafix]

Hi, I'm looking for a constructor in southern Skåne for checking load-bearing capacity and drawing for support replacement if necessary.

Do you have any tips on good constructors in the area?

Tips are warmly welcome as it's not very easy to find someone who takes on small jobs.

There are many knowledgeable people here. By attaching drawings, you can at least get an answer regarding whether it is load-bearing here on the forum.

 

[Cookiiee]

Ok, it doesn't look 100% like the drawing. The chimney is a bit further to the left in reality for some reason, but I have tried to "redraw" it in black. Red is what we will demolish.

Ground floor:

Section drawing:

Basement:

Basement construction drawing:

 

[Cookiiee]

There are many knowledgeable people here. You can, by attaching drawings, at least get an answer on whether it is load-bearing here on the forum.

Thanks for the tip. Uploaded the drawings I got from the municipality.

 

[Tompafix]

Thanks for the tip. Posted the plans I got from the municipality.[/QUO

Most likely, only the basement wall is load-bearing. The roof trusses are self-supporting, so the wall should not take any load. @justusandersson can probably give a better answer.

 

[Anna_H]

The sectional drawing shows no wall there, so it should not be load-bearing, but it's safest for Justus to confirm

 

[ElleH]

Hello, looking for a structural engineer in southern Skåne for checking load-bearing capacity and drawing for replacement if necessary.

Do you have any tips on good structural engineers in the area?

Tips are warmly welcome since it's not very easy to find someone who takes on small jobs.

Hi! Did you find a structural engineer? We are in the same situation 😊

 

[Cookiiee]

Hi! Did you find a constructor? We're in the same situation 😊

Hi, I got the tip to contact Villcon and it worked well. It was admittedly all digital, but they had liability insurance, and I received all the documents with the calculations showing that the wall was not load-bearing.

 

[ElleH]

Okay, thanks! I'll check that!